Carbonyl Sulphide

COS

L

153psig

F,P

Recommended

solution

Minimum

solution

5V-A Gas Panel

The 5V-A automatic gas panel is designed for use with reactive gases that have properties that are harmful to health, pyrophoric, or extremely powerful oxidisers. In order to minimise the risk, the process gas is purged with a suitable inert gas to reduce the hazard prior to cylinder exchange. Full automatic purging and emergency shutdown control is achieved by combining the gas panel with the GCT5VAP-S controller which will operate the air actuated valves in a methodical sequence whilst also performing safety tests and monitoring for the correct pressurisation and evacuation of the area being purged. The design also allows for the two valve protection guideline to be applied during cylinder exchange. A 0.4 micron pre-filter is fitted as standard along with a 10 bar burst disc with monitoring for over pressure protection on the outlet side (for gases with a cylinder/vapour pressure > 120 psig). Further optional enhancements can be found on the datasheet.

5V-M-PEO Gas Panel

The 5V-M-PEO manual gas panel is designed for use with reactive gases that have properties that are harmful to health, pyrophoric, or extremely powerful oxidisers. In order to minimise the risk, the process gas is purged with a suitable inert gas to reduce the hazard prior to cylinder exchange. The additional valves on the low pressure side of the pressure regulator allow for isolation of the gas line and controlled release of the process gas at low pressure in order to protect any downstream abatement systems. The design also allows for the two valve protection guideline to be applied during cylinder exchange. After cylinder exchange, the gas panel is purged with a suitable inert gas to remove the atmospheric contamination prior to the re-introduction of the process gas. An air operated Regulator Inlet Valve, with a manual override fitted to the gas panel for purging purposes, enhances the gas panel to allow for shutdown in the event of an emergency. A 0.4 micron pre-filter is fitted as standard along with a 10 bar burst disc for over pressure protection on the outlet side (for gases with a cylinder/vapour pressure > 120 psig) Further optional enhancements can be found on the datasheet.